There, you’re out.

That’s a lot of bandwidth, but it sounds like a good idea.

They are required to keep it full, my guess is they know that refilling cost that.

Other than that leaves a huge market for SAE spec bolts for use in maintaining the already imperial equipment. As it’s more cost effective to repair up to a point. So some company WILL produce those bolts.

Which is why we’re here with both types of units, and why it’ll be 100+yrs before imperial actually dies.

Maybe a decade of decades. But it’ll eventually get there.

There’s too much infrastructure based on even units in imperial that would “turn into” a partial digit if forced to stay the same.

Example. 1/2"wrench would be the same as a 12.7mm wrench. And a 1/2-13 bolt would be a M12.7x1.9532 bolt.

That stupid conversion makes no sense, so we just use both. Eventually as we replace imperial infrastructure with metric, we’ll use more and more metric, and less imperial. Until eventually it’s all metric. Though a common structural lumber will likely still be called a “2 by 4” even though it’s measurements would theoretically be 35mm X 85mm. And nobody will remember why.

YSK about jury nullification. And you should definitely not claim to know about jury nullification if asked.

But did you remember your notes after?

Power bi. Next time the building loads they’ll be shifted weirdly vertical randomly.

Often this is the case, but there’s also a not insignificant number of times I’m convinced a car with shitty aftermarket bulbs ends up being a new Acura, infinity, or Mercedes when I get close enough to determine the make.

Ok. Found some DNS settings on my router, and fixed the internal domain name “problem” but it’s still only internal. If I set my public IP(internally) it doesn’t connect.

I can connect to an internal computer from external, even though the client says “not ready”.

I cannot connect from internal to external computer. Instantly shows “remote desktop is offline”

This leads me to think that somehow I have something wrong in router settings, or I have a security feature blocking something. I just don’t know enough about routing to know where to look.

I got past the key mismatch internally. Maybe it was blank spaces.idk.

But still having issues externally. Just doesn’t connect for some reason, though I’ve confirmed all the ports are open. :/

It seems I may have “fixed”(?) One problem, as internal network connections succeed now (same key, same settings, just restarted the containers a few times and let it sit?)

External connections still show the same. :/

Especially when they had problems getting the coal they could mine, where it needed to be used.